Task 1 – Learning Outcome 1.1 Determine power series values for common scientific and engineering fu

Task 1 – Learning Outcome 1.1

Determine power series values for common scientific and engineering functions Obtainthe Maclaurin series for the following functions. State the values of the x which the series converge.

cos x/3

ln?(1+x^2)

Task 2 – Learning Outcome 1.2

Solve ordinary differential equations using power series methods. Solve the following ordinary differential equation using Maclaurin series. Task 3 – Learning Outcome 1.3

Solve ordinary differential equations using numerical methods. Use the Euler and the improved Euler methods and comment on the two results. Use the step size shown to advance four steps from the given initial condition with the given differential equation: dV/dt=Vt v(0)=1,h=0.1 Use the Runge-Kutta method with the step size shown to advance four steps from the given initial condition with the given differential equation: dV/dt=t+2V V(0)=1,h=0.1 Write a conclusion on the accuracy and the validity of the above methods used (for Distinction Only) Task 4 – Learning Outcome 1.4

Model engineering situation, formulate differential equations and determine solutions to these equations using power series and numerical methods. During the manufacture of steel component it is often necessary to quench them in a large bath of liquid in order to cool them down. This reduces the temperature of the components to the temperature of the liquid. If T is the temperature of the component in excess of the liquid temperature, the rate of change of the component temperature proportion to the temperature of the component. Take the proportional constant as K. K depends upon the volume and surface area of the component, its specific heat capacity, and the heat transfer coefficient between the component and the liquid. Formulate a differential equation for the above engineering situation Determine a solution for the formulated formula using numerical method and power series, the initial condition that at t=0 the temperature excess is 2500C. Task 5 – Learning Outcome 3.1

Determine Fourier coefficients and represent periodic functions as infinite series. Find the Fourier coefficients of the following equation and write the function as infinite series. f(t)={¦(t&when 0Sketch a graph of the function within and outside of the given range, assuming the period is2p.

Task 6 – Learning Outcome 3.2

Apply Fourier series approach to the exponential form and model of phasor behaviour. Determine the complex Fourier series for the function defined by: f(t)=[¦( 0 -3=t=-1@4 -1=t=2@0 2=t=4)¦ The function is a periodic outside the range of period 7 Task 7 – Learning Outcome 3.3 and 3.4

Apply Fourier series to the analysis of engineering problem Use numerical integration methods to determine Fourier coefficients from tabulated data and solve engineering problems using numerical harmonic analysis In engineering wave analysis, the values of voltage over a complete cycle of a waveform are shown in the table below: Angle (?)

(Degree) Voltage V

(Volts)

0 0

30 -1.4

60 6.0

90 12.5

120 16.0

150 16.5

180 15.0

210 12.5

240 6.50

270 -4.00

300 -7.00

330 -7.50 Use a tabular method to determine the Fourier series for the waveform.

 

Do you need a similar assignment done for you from scratch? We have qualified writers to help you. We assure you an A+ quality paper that is free from plagiarism. Order now for an Amazing Discount!
Use Discount Code "Newclient" for a 15% Discount!

NB: We do not resell papers. Upon ordering, we do an original paper exclusively for you.